White scale and calcium buildup
White crust at the waterline or on tile is calcium scale. It forms when pH, alkalinity and calcium are high at the same time. Bring pH to about 7.4 and alkalinity toward the low end of range, and keep the water balance (LSI) at or slightly below zero while you scrub. The calculator shows your LSI when you enter pH, alkalinity and calcium.
Step by step
- Test pH, alkalinity, calcium hardness and water temperature.
- Lower pH and alkalinity with acid. High temperature makes scale worse, so check again in midsummer.
- Scrub tile with a pumice stone made for pools (not on vinyl or fiberglass), or a scale remover made for your surface.
- If calcium is far above 400 to 500, replace some water. The calculator gives the percentage.
Your exact amounts (example numbers filled in)
Free, no sign-up. Enter your gallons and test results; the calculator gives amounts in cups, quarts and pounds, in the order to add them.
Salt cells and heaters
Scale forms first where water is hottest or most alkaline: inside a heater and on salt cell plates. A scaled salt cell makes less chlorine. Clean it with a cell cleaning solution per the manufacturer.
Common questions
What is LSI?
The Langelier Saturation Index combines pH, alkalinity, calcium and temperature into one number. Above about +0.3 water tends to scale; below about -0.3 it tends to etch plaster.
Can I use vinegar on pool scale?
For small spots on tile, it works slowly. Pool scale removers and pumice are faster.