Otterly

How to clear a green pool

Raise free chlorine to the shock level for your stabilizer, about 40% of your CYA reading (16 ppm if CYA is 40), and keep it there, topping up every few hours, until the water is clear. For a 15,000 gallon pool at CYA 40, getting from 0 to 16 ppm takes 1 gal + 3 qt + 2½ cups of 12.5% liquid chlorine.

Step by step

  1. Test stabilizer (CYA) first. It sets how much chlorine you need. If it is above 80, replace some water before you start, or the chlorine you need gets very high.
  2. Clean or backwash the filter, empty the skimmer and pump baskets, and run the pump around the clock.
  3. Bring pH to about 7.2 to 7.4 if it is high. Chlorine works faster at lower pH.
  4. Add liquid chlorine to reach the shock level. Pour it around the edge with the pump running.
  5. Brush walls and floor at least twice a day. Algae hides in corners, behind ladders and on steps.
  6. Test chlorine every few hours and add more each time it drops below the shock level.
  7. Stop when three things are true: the water is clear, combined chlorine is 0.5 ppm or less, and chlorine drops 1 ppm or less overnight with the sun down.

Your exact amounts (example numbers filled in)

Free, no sign-up. Enter your gallons and test results; the calculator gives amounts in cups, quarts and pounds, in the order to add them.

Why liquid chlorine and not bags of shock

A green pool needs a lot of chlorine for days. Granular shock brings extra baggage: cal-hypo adds calcium with every pound, and dichlor adds stabilizer. Use enough of either to clear a green pool and you raise calcium or CYA for the rest of the season. Liquid chlorine (or plain unscented bleach) adds only chlorine and a little salt.

How long it takes

A pale green pool with a clean filter often clears in two to four days. A swamp with leaves on the bottom can take a week or two. The amount of chlorine the pool eats tells you where you stand: early on, the level can fall to zero within hours. As the algae dies, it holds longer between doses.

The water usually goes from green to blue-gray and cloudy before it turns clear. That cloudy stage is dead algae waiting for the filter. Keep chlorine up and keep the filter clean through it.

If chlorine vanishes as fast as you add it

That is normal for the first day. Keep adding. If you are on day five and it still drops to zero overnight, check the filter, check for debris on the floor, and check CYA again. A pool with no stabilizer loses most of its chlorine to sunlight in a few hours; add chlorine in the evening or add stabilizer.

Common questions

How much chlorine does it take to clear a green pool?

Enough to reach the shock level for your CYA, about 40% of the CYA number, and then enough to hold it there. At CYA 40 that is 16 ppm. In a 15,000 gallon pool, going from 0 to 16 ppm takes 1 gal + 3 qt + 2½ cups of 12.5% liquid chlorine, and you will add more as it gets used up.

My pool has algae and it will not go away. What am I doing wrong?

Usually chlorine is not held at the shock level long enough, or the stabilizer is so high that the shock level is out of reach. Test CYA, hold chlorine at 40% of it day and night, clean the filter, and brush daily until the overnight loss is 1 ppm or less.

Can I swim in a green pool?

No. Green water hides the bottom, so you cannot see someone in trouble, and algae can carry bacteria. Wait until the water is clear and chlorine is back near its normal range.

Should I use algaecide on a green pool?

Chlorine does the killing. Algaecide is optional and works best after the pool is clear, at normal chlorine levels, because high chlorine breaks most algaecides down.

Why did my pool turn green overnight?

Chlorine ran out. Common causes are a hot sunny day with low stabilizer, a heavy swim day, a big rain, or a pump that stopped running. Algae can bloom within a day once chlorine hits zero.